HP StorageWorks LUN Configuration and Security Manager XP user guide for the XP12000/XP10000/SVS200 (T1714-96008, June 2006)

110 LUN Manager operations
4. Right-click any port icon in the Port tree, and select Default Setting(User Name / Secret). The Default
Setting(User Name/Secret) pane appears.
Figure 68 Default Setting(User Name/Secret) pane
Specify the following user information:
• User Name: Fiber Channel’s user name, up to 16 characters. You can use alphanumeric
characters in a user name. User names are case-sensitive.
• Secret: Secret (that is, a password used in CHAP authentication) between 12 to 32 characters. You
can use alphanumeric characters.
• Re-enter Secret: Specify the secret, again, for confirmation.
5. Click OK.
6. Click Apply. A confirmation message appears.
7. Click OK. Settings are applied to the array.
Registering a Fibre Channel switch’s user information
1. Start LUN Manager, and display the Authentication pane (Figure 30).
2. In the Port tree, double-click the Subsystem folder. If the array contains Fibre Channel adapters, the
Fibre folder appears below the Subsystem folder.
3. In the Port tree, double-click the Fibre folder. Information about the Fibre Channel switch appears in
the FC Switch Information list.
4. Right-click any point in the FC Switch Information list, and select Specify User Information. The Specify
Authentication Information pane appears.
Figure 69 Specify Authentication Information pane
Specify the following user information for the host you want to allow to connect:
• User Name: Fibre Channel switch’s user name, up to 16 characters. You can use alphanumeric
characters in a user name.
• Secret: Secret (that is, a password used in CHAP authentication) between 12 to 32 characters. You
can use alphanumeric characters.
• Re-enter Secret: Specify the secret, again, for confirmation.