SVS200 (T1714-96008, June 2006)

86 LUN Manager operations

CAUTION: Before changing a host group’s host mode, HP recommends that you first back up data on

the port the host group belongs to. The operation for changing the host mode should not be destructive,

but data integrity cannot be guaranteed without a backup.

1. Start LUN Manager. The LUN Manager pane (Figure 14) appears.

2. In the tree, right-click the host group, and select Change Host Group. The Change Host Group dialog

box appears.

Figure 47 Change Host Group dialog box

3. To change the name of the host group, enter a new name in the Group Name box.

To change the host mode (Table 16), select the new host mode from the Host Mode list.

4. If necessary, click Option, and select host mode options. For more information about host mode

options, see Table 17 on page 77.

Figure 48 Change Host Group dialog box (Option selected)

NOTE: After you click Option, the pane expands to display a list of host mode options. The No.

column indicates option numbers. Select the check box for the option you want to specify.

5. Click OK. Changes are indicated in blue in the table.

6. Click Apply. A confirmation message appears.

7. Click OK. Changes to the host group name and host mode are applied to the array.

Changing an iSCSI target’s name and host mode

NOTE: You cannot perform this operation on iSCSI targets for initiator ports.