HP StorageWorks LUN Configuration and Security Manager XP user guide for the XP12000/XP10000/SVS200 (T1714-96008, June 2006)

94 LUN Manager operations
To copy one or more (but not all) LU paths defined to a host group or iSCSI target, complete the
following steps:
a. In the tree, select the host group or iSCSI target.
b. In the LU Path table, select one or more LUNs to which volumes are assigned. (If a volume is
assigned to a LUN, columns on the right of the LUN column are not empty.)
c. Right-click the selection, and select Copy Paths. The selected LUNs turn green.
d. Double-click the copy destination port to display host groups or iSCSI targets below the port.
e. Right-click the host group to which you want to paste paths, and select Paste Paths. If a
confirmation message appears, click OK.
NOTE: You cannot paste paths to host groups or iSCSI targets for initiator ports.
4. Click Apply. A confirmation message appears.
5. Click OK. Settings are applied to the array.
Copying paths from one NAS port to another
CAUTION: Before taking the following steps, see ”Notes on using LUN Manager” on page 53 for
important information.
1. Start LUN Manager, and display the LUN Manager pane (Figure 14).
2. To specify the LU paths you want to copy:
a. In the tree, double-click a NAS port (copy source port), and select the User host group.
b. From the LU Path list, select one or more LUNs to which volumes are assigned. If a volume is
assigned to a LUN, columns on the right of the LUN column are not empty.
c. Right-click the selection, and select Copy Paths. The selected LUNs turn green.
3. To paste the LU paths:
a. In the tree, double-click the copy destination port (NAS port). The User host group appears below
the port.
b. Right-click the User host group, and select Paste Paths.
4. Click Apply. A confirmation message appears.
5. Click OK. Settings are applied to the array.
Copying paths from a Fibre Channel or iSCSI port to a NAS port
CAUTION: Before taking the following steps, see ”Notes on using LUN Manager” on page 53 for
important information.
1. Start LUN Manager, and display the LUN Manager pane (Figure 14 or Figure 15).
2. To specify the LU paths you want to copy:
a. In the tree, double-click a Fibre Channel or iSCSI port (copy source port), and select a host group
or iSCSI target. The LU Path list displays information about LU paths.
b. In the list, select one or more LUNs to which volumes are assigned. If a volume is assigned to a
LUN, columns on the right of the LUN column are not empty.
c. Right-click the selection, and select Copy Paths. The selected LUNs turn green.
3. To paste the LU paths:
a. In the tree, double-click a NAS port (copy destination port). The User host group appears below
the port.
b. Right-click the User host group, and select Paste Paths.
4. Click Apply. A confirmation message appears.