SVS200 (T1714-96008, June 2006)

LUN Configuration and Security Manager XP user guide for the XP12000/XP10000/SVS200 95

5. Click OK. Settings are applied to the array.

Copying paths from a NAS port to a Fibre Channel or iSCSI port

CAUTION: Before taking the following steps, see ”Notes on using LUN Manager” on page 53 for

important information.

1. Start LUN Manager, and display the LUN Manager pane (Figure 14 or Figure 15).

2. To specify the LU paths you want to copy:

a. In the tree, double-click a NAS port (copy source port), and select the User host group.

b. From the LU Path list, select one or more LUNs to which volumes are assigned. If a volume is

assigned to a LUN, columns on the right of the LUN column are not empty.

c. Right-click the selection, and select Copy Paths. The selected LUNs turn green.

3. To paste the LU paths:

a. Double-click the Fibre Channel or iSCSI port (copy destination port). Host groups or iSCSI targets

appear below the port.

b. Right-click the host group or iSCSI target to which you want to paste paths, and select Paste Paths.

If a confirmation message appears, click OK.

NOTE: You cannot paste paths to host groups or iSCSI targets for initiator ports.

4. Click Apply. A confirmation message appears.

5. Click OK. Settings are applied to the array.

Viewing a list of alternate paths

1. Start LUN Manager. The LUN Manager pane (Figure 14 or Figure 15) appears.

2. Do either of the following:

•In the LU Path list, right-click a LUN, and select Alternate Paths.

NOTE: If nothing appears in the table cells to the right of a LUN, no path is defined to the LU.

Therefore, no alternative path is defined to the LU.

•In the LDEV table, right-click a logical volume (that is, an LDEV), and select Alternate Paths.

NOTE: If nothing appears in the Paths column for a row in the LDEV list, no alternate paths are

defined to the LDEV corresponding to that table row.