SVS200 (T1618-96004, December 2008)

• Sun® Solaris™ 8 or better. For further information on the Solaris™ platform, refer to the

HP StorageWorks XP Remote Web Console user guide for XP12000/XP10000

• HP-UX 11.0 or better. For further information on the HP-UX platform, refer to the HP StorageWorks

XP Remote Web Console user guide for XP12000/XP10000

• Windows 2000 Advanced Server (Service Pack 3 or later)

• AIX 5L Version 5.1 ML3

Oracle databa

One of the following Oracle databases is required.

• Oracle8i

• Oracle9i

• Oracle9i Release2

NOTE:

Oracle database needs to be constructed in RAW volume. Also, you need to set DB_BLOCK_CHECKSUM

parameter t

oTRUE.

Logical V olume Manager

One of the following Logical Volume Manager versions is required.

• VxVM (for Solaris™)

• LVM (for HP-UX )

• LVM (for AIX )

NOTE:

Versions other than above may be supported in the future enhancement. For the latest information,

contact your HP account support representative.

Restrictions and conventions

When you use Data Integrity Check, or when D ata Integrity Check is installed, the following restrictions

and c onventions are applied.

For arrays:

• You cannot downgrade the microcode (DKCMAIN program) version.

• You cannot replace an existing CHIP which suppor ts Data Integrity Check with a CHIP which

does not

support Data Integrity Check.

• If you uninstall the D ata Integ rity Check license key, you nee d to delete the settings of the volume

to be checked by Data Integrity Check from RAID M anager in advance.

• The set ting of Data Integrity Check can only be deleted using RAID Manager.

• If you w

ant to change the con ﬁguration of the L DEVs (for example, decreasing the set LDEVs,

creat

ing CVs), you need to delete the setting of Data Integrity Check using RAI D Manager

ﬁrst,

and then p erform the change.

Data Integrity Check operating environments and prerequisites