Application Discovery 6.0 Software: User Guide

Explanation of agent states
Table 3-1 Possible values for agent state
MeaningValue
Installed, daemon running, connected; able to transfer data
Connected
Installed, daemon running, disconnected; unable to transfer data
Disconnected
Installed, daemon not running; unable to collect data
Agent not running
No certificates exchanged between Application Discovery server and agent; unable to
complete data transfer. (Applicable to version 4.0 agents only.)
No CMS Cert
Connected to target system; no agent found
Agent not installed
The server cannot connect to the target system. The target system may be down or not
configured for remote command execution from HP SIM.
No contact
See the appropriate Insight Dynamics installation and update guide for instructions on how to
install an Application Discovery agent.
Working with data views
For expanded discussions about what can be seen in each Application Discovery data view, see
the Application Discovery help reference in the software.
Adjusting the user interface
You can alter several visual and behavioral aspects of the Application Discovery user interface
for the duration of your user session. Application Discovery does not store these changes as user
preferences.
To take advantage of these settings, select the following tabs: Admin/Config, then UI. The
following figure shows the controls available from the UI tab.
Figure 3-1 Browser configuration controls in Application Discovery
Set screen data refresh interval
Application Discovery can automatically refresh data to the interface screens at variable intervals.
You can select the interval you prefer, or you can turn the refresh interval off. The default refresh
interval is 20 minutes.
To change the refresh interval, use the “Refresh interval” drop-down to select the setting that
you prefer.
Your selection is applied automatically and immediately.
Working with data views 17