HP Integrity Virtual Server Manager 6.2 User Guide
Table Of Contents
- HP Integrity Virtual Server Manager 6.2 User Guide
- Contents
- 1 Introduction
- 2 Installing Integrity Virtual Server Manager
- 3 Accessing and Navigating Integrity Virtual Server Manager
- 4 Using Integrity Virtual Server Manager views and tabs
- 5 Using Integrity Virtual Server Manager menus
- 6 Working with VMs or vPars
- Working with VMs
- Planning VMs
- Creating VMs
- Modifying VMs
- Starting VMs
- Stopping VMs
- Restarting VMs
- Deleting VMs
- Migrating VMs
- Suspending VMs
- Resuming VMs
- Moving suspend files
- Creating virtual switches
- Starting, stopping, and deleting virtual switches
- Deleting network or storage devices
- Opening iLO console
- Opening virtual iLO remote console
- Deleting virtual iLO remote console
- Deleting DIOs
- Adding DIOs
- Replacing DIO H/W path
- Replacing DIO MAC address
- Working with vPars
- Creating vPars
- Modifying vPars
- Booting vPars
- Stopping vPars
- Resetting vPars
- Creating virtual switches
- Starting, stopping, and deleting virtual switches
- Deleting network or storage devices
- Deleting vPars
- Opening iLO console
- Opening virtual iLO remote console
- Deleting virtual iLO remote console
- Adding DIOs
- Replacing DIO H/W path
- Replacing DIO MAC address
- Deleting DIOs
- Working with VMs
- 7 Collecting and viewing utilization data
- 8 Viewing logs and version information
- 9 Support and other resources
- Information to collect before contacting HP
- How to contact HP
- Security bulletin and alert policy for non-HP owned software components
- Subscription service
- Registering for software technical support and update service
- How to use your software technical support and update
- HP authorized resellers
- New and changed information in this edition
- Related information
- Typographic conventions
- 10 Documentation feedback
- A Error messages, status indicators, and troubleshooting
- Glossary
- Index
Deleting network or storage devices
For details about deleting network or storage devices for vPars, see “Deleting network or storage
devices” (page 105).
Deleting vPars
Deleting a vPar removes all configuration files for the vPar and frees up any resources assigned
to it, thereby the available resources can be assigned to other vPars. Deleting a vPar does not
delete files and data residing on the virtual storage or backing storage that is assigned to the vPar.
NOTE: Before you remove a vPar, you must stop the vPar or put to Off state (powered off).
By default, vswitch VLAN port assignments are removed when the vPar is deleted. If any of the
ports are connected to other vPars that are not removed, those port assignments are not removed.
Clearing the Remove VLAN Assignment check box causes vswitch VLAN port assignments to remain
after the vPar is deleted.
To remove one or more vPars:
1. Select one or more vPars from the Virtual Servers tab.
2. Select Delete→Delete Virtual Partition. The Delete Virtual Partition screen is displayed.
Figure 79 Delete virtual partition
3. Click OK to delete the selected vPars.
Opening iLO console
For details about opening iLO console, see “Opening iLO console” (page 106).
Opening virtual iLO remote console
For details about opening virtual iLO remote console, see “Opening virtual iLO remote console”
(page 107).
Deleting virtual iLO remote console
For details about deleting virtual iLO remote console, see “Deleting virtual iLO remote console”
(page 108).
Adding DIOs
For details about the adding DIOs, see “Adding DIOs” (page 109).
Working with vPars 117