HP Insight Dynamics 6.2 Integrity CMS Installation and Configuration Guide

a. Select Tasks & Logs→View All Scheduled Tasks from the Capacity Advisor menu
bar.
b. Select the task from the list Collect Capacity Advisor Data.
c. Click Edit.
d. Click Schedule.
e. Check the Disable this task check box.
f. Click Done.
g. Verify that the task you just edited is in the list and now shows Task is Disabled
in the Schedule column.
3. Log out of HP SIM.
4. (Optional) Use the capcollect command to collect the latest Capacity Advisor data into
the ID-VSE for Integrity database. For more information, see capcollect(1M).
5. Make a Backup Make a backup of your existing ID-VSE for Integrity database. You
can use this backup if you need to revert to the older version of the software. With this
backup, you can restore your current configuration after reverting to the older version of
the software. You cannot restore this backup after version A.6.2.0.* is installed. Previous
versions of ID-VSE for Integrity used a database format that is incompatible with version
A.6.2.0.*.
For more information about backing up and restoring the ID-VSE for Integrity database
and reverting to a backup from a previous version of the software, see vseinitconfig(1M).
This manpage is included in this manual in Appendix A (page 37).
For information about backing up the HP SIM database, refer to the HP white paper Backing
up and restoring HP Systems Insight Manager data files in an HP-UX or Linux environment,
available from the Information Library link at http://www.hp.com/go/hpsim.
6. If you are upgrading to a new version of HP SIM, follow any upgrade preparation instructions
provided with the new version of HP SIM. In particular, note that you might need to install
additional patches.
After you complete the installation steps in the following sections, see “After upgrading from a
previous version” (page 23) for additional steps that you should perform.
Install the software on the CMS
Use Procedure 3-5 to install HP SIM version 6.0 or later and ID-VSE for Integrity on the CMS.
If you have already installed this version of HP SIM, you can use Procedure 3-6 instead.
16 Installation