HP Insight Dynamics 6.2 Integrity CMS Installation and Configuration Guide

interval="x"
• Ensure that the ticapMode attribute for the sharedResourceDomain element is set
to all if gWLM should allocate Temporary Instant Capacity (TiCAP) when needed:
ticapMode="all"
• Ensure that the workloadReference entries in the compartment definitions are correct,
and adjust the names in the workload definitions themselves. For example, you might
see “host.OTHER.2” instead of “host.OTHER”.
3. Import the file to re-create the SRD:
# gwlm import
Because the SRD was already deployed, the new SRD definition is deployed on import,
taking the place of the original SRD.
Verify Capacity Advisor data migration If you are using Capacity Advisor, use the command
capprofile -lt to verify that previously collected historical data has been migrated to the
new ID-VSE for Integrity database. This command lists the workload profiles and the time range
of the data stored in the database. For more information, see capprofile(1M).
Restore scheduled Capacity Advisor tasks If you are using Capacity Advisor, restore each of
your automatically scheduled Capacity Advisor data collection tasks using Procedure 3-13.
Procedure 3-13 Restore scheduled Capacity Advisor tasks
1. Select Tasks & Logs→View All Scheduled Tasks from the Capacity Advisor menu bar.
2. Select the task from the list Collect Capacity Advisor Data.
3. Click Edit.
4. Click Schedule.
5. Clear the Disable this task check box.
6. Click Done.
7. Verify that the task you just edited is in the list and now shows Periodic in the Schedule
column, along with the date of the next collection.
Postinstallation update of gWLM agents
If you update ID-VSE for Integrity on the CMS to version A.6.2.0.* without updating the gWLM
agent software on some of your managed systems, update those agents as soon as it is convenient
to do so. Use Procedure 3-14 to update the agents.
Procedure 3-14 Update gWLM agents after updating the CMS
1. Undeploy the SRDs that are managing systems where agents are going to be upgraded. Stop
using the existing version of gWLM, including the command-line interface. You can continue
running the gWLM daemons (gwlmcmsd and gwlmagent) and the WBEM service and
provider daemons.
2. Install and start the agents as described in “Install Insight Dynamics agent software and
configure managed systems” (page 21).
3. For any partition-based SRDs, follow the steps described in “Rediscover partition-based
SRDs” (page 23). For SRDs based on PSETs, FSS groups, or virtual machines, redeploy those
SRDs.
To determine if PSETs (HP-UX processor sets, the PROCSETS bundle) is installed use the
swlist ProcessorSets command.
Preparing a Red Hat Linux managed system
OpenPegasus is required for Insight Dynamics of Linux systems. Red Hat (RHEL) distributions
include OpenPegasus, but this is not installed by default. Either manually select OpenPegasus
24 Installation