HP Insight Management 7.3 Update 1 Support Matrix

Table 60 Requirements and capabilities for HP Integrity servers (continued)
Intelligent
Power
Discovery
4
Data
Center
Power
Control
2, 3
Calibrated
Maximum
Power
Power
Metering
Data
Center
Thermal
Mapping
Dynamic
Power
Capping
Power
Regulator
Minimum system
BIOS version
1
Minimum
iLO or OA
firmware
version
Server
model
✓
9
✓✓✓✓iLO 2
version F
Integrity
Superdome
2 03.29 or
later
✓
9
✓✓✓✓iLO 2
version F
Integrity
Superdome
03.29 or
later
1
The BIOS version does not apply to these servers.
2
Data Center Power Control works only on Primary Addresses of a system and cannot detect a system with a non-primary address.
If a system has IPv4 as a primary address and IPv6 as a non-primary address, Data Center Power Control only works with the IPv4
address.
3
For VMhost with only an IPv6 address. Data Center Power Control cannot perform a graceful shutdown of guests. It will only
shutdown the hosts.
4
The Intelligent Power discovery feature is not supported when iPDU is configured with IPv6 addresses only
5
HP Power Regulator for Integrity servers requires Intel Itanium Processor 9100 series Dual-Core 1.6 GHz 18/24 MB parts. It also
requires HP-UX 11.31 with patches PHKL_36654, PHKL_37031, PHKL_37032, PHKL_36477, and PHKL_36478, or Microsoft
Windows Server 2008 with the "HP platform-controlled Power management" driver (other operating systems to be announced). If
Microsoft Windows Server 2008 was factory-installed by HP, the driver is already installed. If you have installed Microsoft Windows
Server 2008, then you must obtain the HP Smart Setup CD and manually install this Smart Component. The Smart Setup CD is
available as part of the HP Integrity Essentials Foundation Pack for Microsoft Windows (T2369AA) or is available from http://
www.hp.com under "Software and Driver downloads" for your platform.
6
Requires iLO firmware version 01.40.42 or later.
7
The DCPC Power ON/OFF action is not supported for this server.
8
Requires iLO firmware version 53.70.02 or later.
9
Supported for nPar only.
Table 61 Requirements and capabilities for HP Integrity NonStop servers
Intelligent
Power
Discovery
4
Data
Center
Power
Control
2,3
Calibrated
Maximum
Power
Power
Metering
Data
Center
Thermal
Mapping
Dynamic
Power
Capping
Power
Regulator
Minimum
system
BIOS
version
1
Minimum
iLO
firmware
versionServer model
✓✓✓N/ANoneIntegrity NonStop
NB50000c
✓✓✓N/ANoneIntegrity NonStop
NB50000c-cg
✓✓✓✓N/ANone
5
Integrity NonStop
NB54000c
✓✓✓✓N/ANone
5
Integrity NonStop
NB54000c-cg
✓N/ANoneIntegrity NonStop
NS16x00
✓N/ANoneIntegrity NonStop
NX160000CG
✓N/ANoneIntegrity NonStop
NS14x00
✓N/ANoneIntegrity NonStop
NS5000cg
80 Hardware requirements and supported capabilities for Insight Control power management