HP Integrity Virtual Machines 4.2: Installation, Configuration, and Administration

• VMProvider — B.04.20 WBEM Provider for Integrity VM, which allows you to use the HP
Integrity VM Manager to manage the VM Host
• VMVirtProvider — B.04.20 Integrity VM Virtualization Provider, which provides support
for logical servers to manage Integrity VM Hosts and guests.
• VMKernelSW — B.04.20 Integrity VM Kernel Software
• HP-UX 11i V3 — HP-UX 11i v3 Virtual Server Operating Environment [VSE-OE] that is
provided for the VM Host system
• PRM-Sw Krn — Installed as part of the HP-UX VSE-OE and required by Integrity VM
• B8465BA — HP WBEM Services for HP-UX, installed as part of the VSE-OE and required
by Integrity VM
2.1.4 Installing VMProvider
To install the VMProvider bundle with the Integrity VM software on the VM Host, enter the
following command:
# swinstall -x autoreboot=true -s my.server.foo.com:/depot/path T2767CC vmProvider
To install the VMProvider bundle with the Integrity VM software on the HP-UX guest, see Section
9.3 (page147):
If you install the VMProvider on either the VM Host or a guest, make sure that the system is
using HP WBEM Services A.02.00.10 or higher. For example:
# swlist WBEMServices
# Initializing...
# Contacting target "alien2"...
#
# Target: alien2:/
#
# WBEMServices A.02.00.11 WBEM Services CORE
Product
WBEMServices.WBEM-CORE A.02.00.11 WBEM Services CORE
Fileset for hp Integrity servers
WBEMServices.WBEM-CORE-COM A.02.00.11 WBEM Services COM
Fileset for hp Integrity servers and hp 9000 servers
WBEMServices.WBEM-MAN A.02.00.11 WBEM Services MAN
Fileset
WBEMServices.WBEM-MX A.02.00.11 WBEM Services MX
fileset
2.1.5 Integrity VM Requires HP WBEM Services on the VM Host
The version of HP WBEM Services for HP-UX must be A.02.00 or later. Integrity VM fails to
install if the version of WBEM Services on your VM Host is not A.02.00 or later.
2.2 Installation Procedure for New Installations
This section describes the installation procedure to use if you have never installed Integrity VM
on your system. If you are updating your HP-UX 11i v2 operating system to HP-UX 11i v3, and
subsequently want to update Integrity VM V3.5 to Integrity VM 4.2, see Section 2.3 (page 31).
If you are updating Integrity VM V4.0 to Integrity V4.2, see Section 2.4.
Once you have read the product release notes and verified that you have met the system
requirements as described in Section 2.1.1 (page 27), install the Integrity VM software as described
in this section.
NOTE: Installing the Integrity VM software requires the system to reboot. Therefore, the
swinstall command line installation includes the autoreboot=true parameter.
To install the HP Integrity VM software, follow these steps:
2.2 Installation Procedure for New Installations 29