HP Matrix Operating Environment 7.3 Recovery Management User Guide

1. Shut down the applications and operating system on each Matrix recovery management DR

Protected logical server and each server associated with DR Protected IO services.

2. Click on the Deactivate... button and the Deactivate Recovery Groups at the Local Site window

will appear.

For more information about the Recovery Groups contained in a Recovery Group Set, select

the Recovery Group Set and click View Recovery Group. A window will appear displaying

the following parameters for each Recovery Group in the Recovery Group Set:

• Name

• Status

• Type

• Preferred Site

• Secondary Site

• Storage Replication Group Name

• Start Order

• Power-Up Delay

3. Click the check-box on the left side of the banner of the Deactivate Recovery Groups at the

Local Site window to select all of the Recovery Group Sets at the Local Site for deactivation.

4. Click Deactivate Recovery Groups to start the deactivation operation. A window will appear

asking if it is OK to proceed. Click OK and you will be directed to the Jobs tab where you

can monitor the progress of the deactivation Job.

NOTE: If the Matrix recovery management configuration includes Hyper-V logical servers

or IO services, bring the cluster disk resource used for logical server or IO service storage

offline prior to activating operation at the remote site. If you did not take the CSV offline, see

“Recover the CSV from online pending state” (page 71) for how to recover.

At the site you want to fail over to:

1. Ensure that enough resources are available to run the logical servers that will be activated at

this site.

2. Click on the Activate... button and the Activate Recovery Groups at the Local Site window will

appear.