HP Insight Management 7.3 Installation and Configuration Guide

the software performance or behavior. However, the target location must meet the following
requirements:
• The target directory must be on a local hard disk drive. Some products might not install if the
target directory is a mapped or a shared drive.
• The target hard disk must have enough temporary space to complete the installation in addition
to the space required for Insight Management products you plan to install. To determine the
disk space you need for Insight Management products, see the HP Insight Management Support
Matrix.
Figure 9 Installation directory
New installation
Select the installation location by performing one of the following steps:
• To use the default directory location, click Next.
• To select a different directory, click Browse, or enter the path in the Installation Directory field,
and then click Next.
Upgrade
For an upgrade scenario, you cannot change the installation directory. If you installed a component
as a standalone previously (not using the HP Insight Management Installer), the HP Insight
Management Installer upgrades that component in the original installation location.
Click Next.
IMPORTANT: The remaining screens in the Installer appear based on the software you chose to
install, and some screens do not appear at all during an upgrade because information previously
entered is reused for the upgrade. Skip the screens that do not apply to your installation.
22 Installing or upgrading HP Insight Management