HP Matrix Operating Environment 7.0 Integrity CMS Installation and Configuration Guide (7.0 and 7.1)

Procedure 4 Install or upgrade Systems Insight Manager and Matrix OE for HP-UX
1. Enter the following command on the CMS:
# /usr/sbin/swinstall -x autoreboot=true \
-s path-to-depot-file HPSIM-HP-UX VSEMgmt
IMPORTANT: The system reboots after the installation.
The actions that occur after system reboot depend on whether this is a new installation of
Systems Insight Manager or an upgrade to an existing Systems Insight Manager installation.
New installation of Systems Insight
Manager
Configure Systems Insight Manager by entering the
following command on the CMS:
# mxinitconfig -a
Upgrade of an existing installation
of Systems Insight Manager
The system automatically runs mxinitconfig after
the reboot. This can take up to 20 minutes to complete.
Do not attempt to run any Systems Insight Manager
commands or Insight Management management
commands, or access Systems Insight Manager through
the web interface at this time.
Other steps might be required to complete the Systems
Insight Manager upgrade. For example, you might
need to reidentify all discovered systems to complete
the database upgrade for existing systems in the
database.
2. (optional) If Oracle version 10g is installed on a server in your environment, you can configure
Systems Insight Manager and Matrix OE for HP-UX to use an Oracle database instead of the
defaultPostgreSQL database for internal data management. For specific requirements for using
Oracle with Matrix OE for HP-UX, see HP Insight Management Support Matrix .
To configure Systems Insight Manager for Oracle, use the following steps:
a. Ensure that Oracle 10g is installed and running on the Oracle server.
b. Copy the file ojdbc14.jar from your Oracle 10g server to a location on your CMS.
NOTE: Do not rename this file. It must be named ojdbc14.jar when it is installed by
mxoracleconfig in the next step.
c. Configure Systems Insight Manager by entering the following command on the CMS:
# mxoracleconfig [-h hostname] [-n port-number] \
-d database-name -u username -p password \
-j path-to-jar-file/ojdbc14.jar [-f]
For details about the mxoracleconfig command, see mxoracleconfig(1M).
d. Reinitialize Systems Insight Manager by entering the following command on the CMS:
# mxinitconfig -a
3. Run the msswinitconf -a command to configure Insight managed system setup wizard
on the CMS:
# msswinitconfig -a
IMPORTANT: On an Integrity CMS the msswinitconfig command must be executed after
installing the software and configuring Systems Insight Manager, but prior to executing
vseinitconfig. An error message will be issued by vseinitconfig if this step has not
been performed.
You must run msswinitconfig before running Insight managed system setup wizard for
the first time.
12 Installation