HP Matrix Operating Environment 7.0 Integrity CMS Installation and Configuration Guide (7.0 and 7.1)

(see HP Matrix Operating Environment for HP-UX Installation
and Configuration Guide).
On an HP-UX CMS, the optional --clobber or -F option
causes an existing Matrix OE database to be removed
without being backed up first. If that option is not used, then
an existing database will be upgraded from the previous
version of Matrix OE. This does not apply to a Microsoft
Windows CMS.
NOTE: HP recommends backing up your entire CMS
configuration before upgrading from a previous version of
Matrix OE. For details about this and other upgrade
considerations, see the Matrix OE installation guide (HP
Matrix Operating Environment for HP-UX Installation and
Configuration Guide or HP Insight Management Installation
and Configuration Guide), and review the notes in the
description of the --restore option below.
-F|--clobber Clear any existing Matrix OE database without backing it
up. For more information about how this option affects
vseinitconfig, see the descriptions of the options
-a|--initconfig and -r|--unconfig.
-q|--quiet Do not display any output. Do not prompt for HP SIM restart
after performing the initial configuration operation. You can
view the console and error output in the log files.
-x restart_sim={true|false} This option selects whether to automatically restart HP SIM
after initial configuration of Matrix OE. It only applies in
combination with the initial configuration option (-a or
--initconfig) or the “unconfigure” option (-r or
--unconfig).
Use -x restart_sim=true to restart HP SIM without
any further prompting after all of the Matrix OE applications
are configured. There can be a delay of one or two seconds
after vseinitconfig finishes execution before HP SIM is
ready to respond to mx... commands.
Use -x restart_sim=false to return immediately after
all of the Matrix OE applications are configured, without
restarting HP SIM.
If this option is not used, you will be prompted whether to
restart HP SIM after all of the Matrix OE applications are
configured.
-r|--unconfig Remove the installed Matrix OE tools from HP SIM. The
existing database and configuration information will not be
removed unless the optional --clobber or -F option is
used.
Important: The optional --clobber or -F option causes
an existing Matrix OE database to be removed without
being backed up first. If you do not perform a backup of
the Matrix OE database before executing this command,
you will lose all of your Matrix OE data, including gWLM
and Capacity Advisor configuration and historical data.
On a Microsoft Windows CMS, vseinitconfig -r is
automatically invoked by the installer. On an HP-UX CMS,
you must execute the command before removing the software
32 Command reference