Building Disaster Recovery Serviceguard Solutions Using Metrocluster with Continuous Access XP P9000 for Linux B.12.00.00

ManualsBrandsHP ManualsSoftwareHP Metrocluster with 3PAR Remote Copy E-LTU

# run the raidscan command on ftsys1a or ftsys2a that is connected to the

# remote XP array.

# The HORCM_LDEV parameters are used to describe

# stable LDEV# and Serial# as another way of HORCM_DEV used 'port#,Target-ID,LUN'.

# [Note]:

# This feature depends on the micro version of RAID or kind of RAID.

# <dev_group>

# This parameter is used to define the device group name for paired logical

# volumes. The device group name is used by all Raid Manager commands for

# accessing these paired logical volumes.

# <dev_name>

# This parameter is used to define the names of the paired logical volumes

# in the device group.

# <Serial#>

# This parameter is used to describe the Serial number of RAID box.

# <CU:LDEV(LDEV#)>

# This parameter is used to describe the LDEV number in the RAID box,

HORCM_LDEV

#dev_group dev_name Serial# CU:LDEV(LDEV#) MU#

pkgA pkgA_index 60095 01:04 0

pkgA pkgA_logs 60095 01:05 0

pkgB pkgB_d1 60095 01:06 0

pkgC pkgC_d1 60095 01:07 0

pkgD pkgD_d1 60095 01:08 0

HORCM_INST

#dev_group ip_address service

pkgA ftsys1 horcm0

pkgB ftsys1 horcm0

pkgC ftsys1 horcm0

pkgD ftsys1 horcm0

Sample RAID Manager configuration file for the Virtual Command Device

This section includes a sample RAID Manager configuration file for the virtual command device.

For this sample, following are the configuration details:

• ftsys1 and ftsys2 are part of primary site

• ftsys1a and ftsys2a are part of recovery site

• horcm0 is the local array Raid manager

• 10.0.0.1 is the IP address of the service processor

• 31001 is the UDP communication port number

The following is an example of a RAID manager configuration file for one node (ftsys1).

## horcm0.conf.ftsys1- This is an example Raid Manager configuration

# file for node ftsys1.Note that this configuration file is for Raid

# Manager instance 0, which can be determined by the "0" in the filename

# "horcm0.conf".

# Whenever this configuration file is changed, you must stop and restart

# the instance of Raid Manager. This can be done using the following commands:

# horcmshutdown.sh <instance>

# horcmstart.sh <instance>

# After restarting the Raid Manager instance, you must confirm that there

# are no configuration errors reported by running the pairdisplay command

# with the "-c" option.

HORCM_MON

#ip_address service poll_interval(10ms) timeout(10ms)

ftsys1 horcm0 1000 3000

HORCM_CMD

\\.\IPCMD-10.0.0.1-31001

HORCM_DEV

#dev_group dev_name port# TargetID LUN#

68 Sample configuration files for Metrocluster with Continuous Access XP P9000 for Linux B.01.00.00