Neoview Database Administrator's Guide (R2.2)

Table 8-2 Optional CONFIG_TASK_LOAD Arguments (continued)
DescriptionDefault
Value
Long
Name
Short
Name
Specifies whether recovery is enabled. Valid values are:
Y (yes, enable recovery)
N (no, do not enable recovery)
If you are upgrading from a prior release, any tasks created
under that release will be run with recovery disabled, which
was the previous default.
Y (in current
release)
recoveryFlag-rf
Name of the data source server; maximum 32 characters. For
example:
LINUX-CMSERVER
This will be picked up from the values provided when the
loader software was installed on the Linux system.
Provided by
system
sourceServerName-sn
Name of the data source system; maximum 32 characters. For
example:
BMC011
This will be picked up from the values provided when the
loader software was installed on the Linux system.
N.A.
sourceSystemName-ss
The number of records sent in a single request from the Linux
server to a data load server on the Neoview platform. For
INSERT tasks this is the number of records that will be
committed to the database in a single transaction. Maximum
size is 50000.
Take care when setting transactionSize because it can
have a large impact on performance. For more information,
see “Transaction Size Limit” (page 99).
2500
transactionSize-ts
Task type. Valid values are:
BATCH
REAL
BATCH
taskType-tt
Arguments for Starting a Task
Table 8-3 START_TASK Arguments
DescriptionDefault
Value
Long
Name
Short
Name
Start task request. Must be set to
START_TASK
N.A.
requestType-rt
Task name. For example:
MYTASK1
N.A.
taskName-tk
Name of the task instance; maximum 32 characters. For
example:
MYTASK1_INS1
If you do not enter a value, the loader will generate one.
N.A.
taskInstanceName-ti
Command-Line Arguments for Load Tasks 113