WB.15.15

ManualsBrandsHP ManualsSoftwareHP Network Protector SDN Application 250 Concurrent Clients E-LTU

Tx 5 Minute Weighted Average Rate (Pkts/sec): 0

Rx Heartbeat : 0

Tx Heartbeat : 0

Last Recv Heartbeat Timestamp : 01/01/90 00:00:00

show interface tunnel command

Example

‘show interface tunnel’ command displays the tunnel information with supported fields. Unsupported

fields are indicated with /n/a’.

HP-E8206zl# show interface tunnel

Tunnel Configuration :

Tunnel : 1000000001

Tunnel Name : ServiceTunnel-01

Tunnel Status : Enabled

Source Address : 1.1.1.1

Destination Address : 1.1.1.2

Mode : Service Tunnel

TOS :

TTL :

IPv6 : n/a

MTU :

Current Tunnel Status :

Tunnel State : Up

Destination Address Route:

Next Hop IP :

Next Hop Interface :

Next Hop IP Link Status :

Source Address :

Example

‘show interface tunnel brief’ displays the tunnel information with supported fields.

HP-E8206zl# show interface tunnel brief

Tunnel : 1000000001

Mode: Service Tunnel

Source Address : 1.1.1.1

Destination Address : 1.1.1.2

Configured Tunnel Status: Enabled

Current Tunnel State : Up

Example

‘show interface tunnel <Tunnel-ID-List>’ displays the tunnel information with supported fields.

Unsupported fields are indicated with /n/a’.

HP-E8206zl# show interface tunnel 1000000001

Tunnel Configuration :

Tunnel : 10

Tunnel Name :

Tunnel Status : Enabled

Source Address : 1.1.1.1

Destination Address : 1.1.1.2

Mode : Service Tunnel

10 Service Insertion