HP Service Insertion Guide K/KA/WB.15.15

Encapsulation is TUNNEL, Service-loopback-group ID n/a
Tunnel source 10.10.10.1, destination 10.10.10.2
Tunnel bandwidth n/a
Tunnel protocol/transport GRE/IP
Last clearing of counters:n/a
Last 300 seconds input:n/a
Last 300 seconds output:n/a
0 packets input, 0 bytes
0 input error
0 packets output, 0 bytes
0 output error
Clear command
The Clear command is used to delete the service tunnels and clear the statistics on the switch.
Syntax
HP-E8206zl# clear interfaces tunnel type intercept {all | <Interface-Index> | statistics [all |
<Interface-Index>]}
type Specify the Service Tunnel type
intercept Delete the Service Tunnel or reset the statistics for all the sessions
all Delete all Service Tunnels of type intercept
Interface-Index Delete a specific Service Tunnel of type intercept
statistics Reset the statistics of the Service Tunnel of type intercept
Example
HP-E8206zl# clear interfaces tunnel type intercept all
This command will delete all the Service Tunnels of type intercept. Make sure the tunnels are not in use by any
application. Continue (y/n)?
Example
HP-E8206zl# clear interfaces tunnel type intercept 1000000001
This command will delete the specified Service Tunnel of type intercept. Make sure the tunnel is not in use by
any application. Continue (y/n)?
Debug command
Syntax
HP-E8206zl# debug tunnel intercept
Description: Enable debug logging for Service Tunnel of type intercept
HP-E8206zl# debug tunnel intercept heartbeat
Description: Enable heartbeat debug logging for Service Tunnel of type intercept
Show Tech Service Tunnel command
Syntax
HP-5406zl# show tech tunnel intercept
show interfaces tunnel type intercept
Status - Service Tunnel Information Brief
Max. Supported Tunnels : 16
Total Tunnels : 2
Interface Index : 100663627
Name : ServiceTunnel-02
Key : 212
Local Address : 10.0.0.1
Remote Address : 57.50.50.50
Interface State : Down
12 Service Insertion