HP OneView 1.10 Installation Guide
Table Of Contents
- HP OneView 1.10 Installation Guide
- Contents
- 1 Preparing for installation
- 2 Installing HP OneView on a VM host
- 3 Support and other resources
- 3.1 Gather information before contacting an authorized support representative
- 3.2 How to contact HP
- 3.3 Get connected to the HP OneView online user forum
- 3.4 Software technical support and software updates
- 3.5 Related information
- 3.5.1 Product bulletins and Quick Specs for all HP products
- 3.5.2 HP OneView documentation and websites
- 3.5.3 Enclosure, iLO, and server hardware documentation and websites
- 3.5.4 HP 3PAR StoreServ Storage documentation and websites
- 3.5.5 HP Virtual Connect documentation and websites
- 3.5.6 Finding documents on the HP Support Center website
- 3.6 Submit documentation feedback
- A About using your appliance
- B Troubleshooting installation issues
B.5 VM does not restart when the vSphere VM host time is manually set
Possible cause and recommendationSymptom
You are not using NTP and the VM host time was incorrectly set to a time in
the past.
The appliance VM
does not restart and
the following error
• Reset the time settings on the VM host to the correct time, and then restart the VM appliance.
For more information, see your vSphere documentation.
appears in the
vSphere virtual
console: The
• If the appliance or VM host is configured as an NTP client, ensure that the NTP server is
working correctly.
superblock last
mount time is in
NOTE: For recommended best practices for managing the appliance VM, see “Best practices
for managing a VM appliance” (page 21).
the future
UNEXPECTED
INCONSISTENCY;
RUN fsck
MANUALLY.
24 Troubleshooting installation issues