HP OneView 1.10 Support Matrix
For HP Virtual Connect 8Gb 20-port Fibre Channel and HP Virtual Connect 8Gb 24-port Fibre
Channel modules
• Interconnect modules are for Fabric attach only.
• Interconnect firmware version must be at or higher than the firmware version listed in “Minimum
firmware requirements” (page 7).
• Interconnect modules cannot be placed in bays 1 or 2.
For HP Virtual Connect FlexFabric–20/40 F8 modules
• Interconnect module requires 10 fans in an enclosure.
• Do not insert more than six HP Virtual Connect FlexFabric–20/40 F8 modules in one enclosure.
• If configured for 4x10G operation, a pluggable module with an attached splitter cable must
be installed to multiplex the QSFP+ port into four SFP+ ports on the remote end.
• HP Virtual Connect FlexFabric-20/40 F8 modules are not supported in generation 1 HP
BladeSystem c7000 enclosures.
2.8 Interconnect modules 13