HP OneView 1.10 Support Matrix

2.9 FLB or Mezzanine card–VC module configurations
HP OneView supports network connectivity through the following FLB (Flexible LOM for blades) or
mezzanine card–HP Virtual Connect module configurations.
Table 8 Supported FLB/mezzanine card–VC module configurations
Ethernet
Adapters
1
560FLB
560M
361FLB
366M
NC325m
NC360m
NC364m
NC382m
Flex-10
Adapters
530FLB
530M
552M
NC532m
NC542m
NC550m
NC552m
FlexFabric
Adapters
534FLB
534M
554FLB
554M
NC551i
NC551m
NC553i
NC553m
Configuration
No
connectivity
4 FlexNICs
per physical
port
(Ethernet
only)
4 FlexNICs
or 3
FlexNICs
and 1
FlexHBA per
physical
port
2
HP Virtual Connect FlexFabric 10Gb/24-port Module
4 FlexNICs per physical
port (Ethernet only)
HP Virtual Connect Flex-10/10D Module
HP Virtual Connect Flex-10 10Gb Module
2x physical ports
1
Ethernet Interconnect (external manager)
1
Not managed by HP OneView. HP OneView retains the physical ports in their unconfigured, default state. You can
obtain network connectivity using a standard Ethernet interconnect or Ethernet passthrough module in the adjacent IO
bays of the enclosure.
2
One of the four FlexNICs can be configured for storage functionality using FCoE (Fibre Channel over Ethernet) or iSCSI
(Internet Small Computer System Interface). Ethernet is available on all four FlexNICs. HP OneView configures FlexNIC
network connectivity using server profile connections, such as device type, network or VLAN settings, and QoS (Quality
of Service) or bandwidth settings.
2.10 Racks and power
• HP Intelligent Power Distribution Units (Firmware version 1.4 and later)
• HP Intelligent Series Racks
• HP Location Discovery Services for Software and Firmware (HP ProLiant DL Gen8 rack mount
servers and HP BladeSystem c7000 G3 enclosures only)
14 Supported hardware