HP OneView 1.01 Release Notes

ResolutionIssue

To manually align the power state of the server hardware

and HP OneView, perform a Refresh action from the Server

HP ProLiant G7 server blade does not reflect correct power

state in HP OneView, if controlling power outside of HP

OneView. Hardware screen. In general, HP recommends using HP

OneView to control power to the server hardware, which

avoids this misalignment.

Update the firmware on the HP ProLiant G7 blade,

including the HP NC55x to the latest HP Service Pack for

HP ProLiant G7 server blade will not boot from SAN

because the FlexFabric NC55x adapter Converged Network

Adapter firmware is below the supported minimum. ProLiant, physically remove the server blade from the

enclosure, delete the server hardware type, and then

re-insert the server blade.

Boot the server through POST (power on self-test), enter

RBSU, exit RBSU, power off the server, and apply the

profile again.

HP ProLiant G7 server blade has incorrect boot controller

order if the profile is applied after resetting the BIOS to

factory defaults via the RBSU (ROM Based Setup Utility –

F9).