HP OneView 1.05 User Guide

• For Server hardware type, select BL460c Gen8 Standard.
• For Enclosure Group, select DirectAttachGroup.
• For Firmware Baseline, select Manage manually.
3. Click Add Connection to open the Add Connection dialog box.
4. Add two connections to the prod networks network set. Because the configuration is the
same for both network sets, you can enter the information, and then click Add + twice to add
both connections and reopen the dialog box for the next step.
ValueAttribute
EthernetDevice type
prod networksNetwork
2.5 (the default value)Requested bandwidth
Auto (the default value)FlexNIC
For both connections, select Not bootable.Boot
5. Add one connection to the FlatSAN A network. Enter the information shown in the following
table, and then click Add + to add the connection and reopen the dialog box for the next
step.
Fibre ChannelDevice type
FlatSAN ANetwork
2.5 (the default value)Requested bandwidth
Auto (the default value)FlexNIC
Not bootableBoot
A.6 Configuring a server blade to boot from the attached HP 3PAR Storage System 281