HP OneView Deployment and Management Guide 1.05

Technical white paper | HP OneView Deployment and Management Guide

Supported Servers

• All HP ProLiant Gen8 BL-family of servers

• All HP ProLiant Gen8 DL-family of servers

• BL460/465 G7

• BL490 G7

• BL685 G7

• BL680 G7

Supported IO Adapters

• All HP Flex-10 and FlexFabric 10Gb adapters

• BladeSystem HBA’s are allowed, but will be unmanaged and must be connected to non-Virtual Connect FC modules.

Supported Interconnects

• HP Virtual Connect FlexFabric 10Gb/24-Port Module

• HP Virtual Connect Flex-10 10Gb Ethernet Module

• HP Virtual Connect Flex-10/10D Ethernet Module

Hardware Firmware Minimum Requirements

Table 3 shows the minimum firmware requirements needed to successfully import an enclosure. Firmware will be updated

via the appliance to the required versions later in this document.

Table 3. Minimum Firmware Requirements

Onboard Administrator

3.00 or newer

iLO4

1.01 or newer

iLO3

1.20 or newer

Virtual Connect

3.15 or newer

Table 4. Post Import Firmware Minimum Version

Onboard Administrator

4.01

iLO4

1.30

iLO3

1.61

Virtual Connect

4.10

Note

The Appliance Virtual Machine should not be deployed on a hypervisor within the same enclosure it will manage. Please use

an externally available hypervisor host.

Table 5 shows the HP OneView 1.0 and 1.05 Configuration Maximums.

Table 5. Supported Maximums

Total Servers

640

Servers per Enclosure

Total Enclosures