FW 05.01.00 and SW 07.01.00 HP StorageWorks SNMP Reference for Directors and Edge Switches Reference Guide (AA-RQ7BD-TE, June 2003)

SNMP Support
109SNMP Reference for Directors and Edge Switches
FcConnUnitPo
rtProtocolOp
(added from
Mib3.0)
OCTET
STRING
(SIZE (2))
If the port is Not installed
fcConnUnitPortProtocolOp
= 0
else if the Port State is
offline
fcConnUnitPortProtocolOp
= 0
else it depends on the
operating Port Type:
F_Port 2 = Fabric(2)
FL_Port 1 = Loop(1)
E_Port 2 = Fabric(2)
H_Port 1 = Loop(1)
B_Port 2 = Fabric(2)
R Bit mask that specifies the
driver level protocol(s) that
are currently operational. If
this is not applicable, return
all bits set to zero. This object
has the same definition as
fcConnUnitPortProtocolCap.
FcConnUnitPo
rtNodeWwn
(added from
Mib3.0)
FcNameI
d
switch WWN R The Node World Wide
Name of the port if
applicable, otherwise all
zeros. This should have the
same value for a group of
related ports. The container is
defined as the largest
physical entity. For example,
all ports on HBAs on a host
will have the same Node
WWN. All ports on the same
storage subsystem will have
the same Node WWN.
FcConnUnitPo
rtHWState
(added from
Mib3.0)
INTEGER See “Port State
Descriptions” on page 143.
R The hardware detected state
of the port. The values are
defined as follows: unknown
(1), failed (2) – port failed
diagnostics, bypassed (3) –
FCAL bypass, loop only,
active (4) – connected to a
device, loopback (5) – Port in
ext loopback, txfault (6) –
Transmitter fault, noMedia (7)
– media not installed,
linkDown (8) – waiting for
activity (rx sync).