FW 05.01.00 and SW 07.01.00 HP StorageWorks SNMP Reference for Directors and Edge Switches Reference Guide (AA-RQ7BD-TE, June 2003)

SNMP Support
42 SNMP Reference for Directors and Edge Switches
ifInErrors Counter R The number of inbound packets that
contained errors preventing them from being
deliverable to a higher-layer protocol.
ifInUnknownP
rotos
Counter R The number of packets received via the
interface which were discarded because of
an unknown or unsupported protocol.
ifOutOctets Counter R The total number of octets transmitted out of
the interface, including framing characters.
ifOutUcastPkts Counter R The total number of packets that higher-level
protocols requested be transmitted to a
subnetwork-unicast address, including those
that were discarded or not sent.
ifOutNUcastP
kts
Counter R The total number of packets that higher-level
protocols requested be transmitted to a
non-unicast (i.e., a subnetwork-broadcast or
subnetwork-multicast) address, including
those that were discarded or not sent.
ifOutDiscards Counter R The number of outbound packets which were
chosen to be discarded even though no
errors had been detected to prevent their
being transmitted. One possible reason for
discarding such a packet could be to free up
buffer space.
ifOutErrors Counter R The number of outbound packets that could
not be transmitted because of errors.
ifOutQLen Gauge R The length of the output packet queue (in
packets).
ifSpecific OBJECT IDENTIFIER R A reference to MIB definitions specific to the
particular media being used to realize the
interface. For example, if the interface is
realized by an Ethernet, then the value of this
object refers to a document defining objects
specific to Ethernet. If this information is not
present, its value should be set to the OBJECT
IDENTIFIER { 0 0 }, which is a syntactically
valid object identifier, and any conforming
implementation of ASN.1 and BER must be
able to generate and recognize this value.