FW 05.01.00 and SW 07.01.00 HP StorageWorks SNMP Reference for Directors and Edge Switches Reference Guide (AA-RQ7BD-TE, June 2003)

SNMP Support
75SNMP Reference for Directors and Edge Switches
FcFxPortPhysOper
Status
INTEGER FPM,
SNMP
R The current operational status of the
FxPort. The testing(3) indicates that no
operational frames can be passed. If
fcFxPortPhysAdminStatus is offline(2)
then fcFxPortPhysOperStatus should be
offline(2). If fcFxPortPhysAdminStatus is
changed to online(1) then
fcFxPortPhysOperStatus should change
to online(1) if the FxPort is ready to
accept Fabric Login request from the
attached NxPort. It should proceed and
remain in the link-failure(4) state if and
only if there is a fault that prevents it
from going to the online(1) state. The
values are defined as follows: online(1)
– Login may proceed, offline(2) – Login
cannot proceed, testing(3) – port is
under test, link-failure(4) – failure after
online/testing.
See “Port State Descriptions” on
page 143.
FcFxPortPhysLastC
hange
TimeTicks SNMP R The value of sysUpTime at the time the
FxPort entered its current operational
status. A value of zero indicates that the
FxPort’s operational status has not
changed since the agent last restarted.
This is SS_TIM_RD_TICKS(MILLISEC) *
10.
FcFxPortPhysRttov MilliSecond
s
SNMP R The Receiver_Transmitter_Timeout value
of the FxPort. This is used by the receiver
logic to detect Loss of Synchronization.
This value is fixed at 100ms.