FW V06.XX/HAFM SW V08.02.00 HP StorageWorks HA-Fabric Manager Appliance Installation Guide (AA-RU5FB-TE, July 2004)

Chapter 2. Installation
Note
Figure 2-1 depicts the right-side rails of the cabinet. This figure does not depict the
square alignment washers required if you are installing the bar nuts in an HP 9000,
10000, or 110
00 series cabinet.
b. Attach each bar nut using two screws (first and third holes) per nut.
Note
If you are in
stalling the bar nuts on an HP 9000, 10000, or 11000 series cabinet, add
a square alignment washer to each sc rew, orienting the protruding alignment bumps
with the rack-mounting standard.
c. Partiall
y tighten each screw, leaving enough space for the front and rear bracket
flanges to insert between the rack-mounting standards and bar nuts.
4. Depending on the cabinet depth measured in step 2, attach each front bracket to a rear
(short or long) bracket. If the cabinet depth is under 22 inches, use one front bracket and
one short
rear bracket. If the cabinet depth is over 22 inches, use one front bracket and
one long rear bracket.
Be sure to choose the slots in the rear bracket which will result in the length of the
combined front and rear bracket to match the cabinet depth measured in step 2.
a. Using a #2 Phillips screwdriver and two (2) flat-head Phillips machine screws (#8
x7/16)pe
r bracket assembly, connect a front and rear bracket together with a
two-hole bar nut as shown in Figure 2-2.
hp StorageWorks HA-F abric Manager A ppl iance Installation
Guide
25