FW V06.XX/HAFM SW V08.02.00 HP StorageWorks HA-Fabric Manager Appliance Installation Guide (AA-RU5FB-TE, July 2004)

Chapter 2. Installation
Figure 2.3. Bracket Installation
a. Slide the mounting bracket flanges between the bar nuts and rack-mounting
standards. Adjust the overall length of each bracket assembly if required.
b. To allow tolerance for appliance installation, tighten the three-hole bar nut screws
(bracket-to-rack mounting standard) so the brackets are stable, but can be moved
laterally.
Note
Ensure the bar nut screw washers to do not overlap the inside edges of the rack-mounting
standards and mounting brackets. Washer overlap may interfere with slide rail operation.
c. Using a #2 Phillips screwdriver, securely tighten the bar nut screws (two per bracket
assembly, four total) that connect the front and rear brackets.
Installing Slide Rails
To attach the left and right sli
de rails to the HAFM appliance:
1. As shown in Figure 2-4, attach the left and right slide rails to the appliance with ten
(10) pan-head Phillips screws (M4 x 10 cm). Use five (5) screws per side. Ensure the
screws are securely tightened.
hp StorageWorks HA-F abric Manager A ppl iance Installation
Guide
27