FW V06.XX/HAFM SW V08.02.00 HP StorageWorks HA-Fabric Manager Appliance Installation Guide (AA-RU5FB-TE, July 2004)

Chapter 2. Installation
Figure 2.5. Appliance Installation
3. Using a #2 Phillips screwdriver, securely tighten the bar nut screws (four per assembly,
eight total) that connect the bracket assemblies to the rack-mounting standards.
4. Install one hexagonal-nut standoff per side (two total) to prevent the appliance from
moving. At the front of the appliance (as shown in Figure 2-6), screw a standoff through
the remaining (center) hole where each three-hole bar nut attaches to the rack-mounting
standard. Secure each standoff with a 5/16 open-end wrench.
Note
If you a re installing the ser ver in an HP 9000, 10000, or 1100 0 series rack you will also
need to install a square alignment washer with each hexagonal-nut standoff.
5. As shown in Figure 2-6, use the two (2) remaining pan-head Phillips screws (#10 x
1/2) to secure the appliance rack-mount ears (factory-installed on the appliance) to the
hexagonal-nut standoffs. Secure the screws with a #2 Phillips screwdriver.
hp StorageWorks HA-F abric Manager A ppl iance Installation
Guide
29