FW V06.XX/HAFM SW V08.02.00 HP StorageWorks HA-Fabric Manager Appliance Installation Guide (AA-RU5FB-TE, July 2004)

Chapter 3. Configuration
Configuring Public LAN Addresses
Note
Befor e starting this procedure, ensure that the LAN 1 interface is physically connected to the LAN.
An LCD display of 0.0.0.0 indicates a physical LAN connection is not present.
You can confi
gure the public LAN connection (LAN 1) using one of the following methods:
• Use Dynamic
Host Control Protocol (DHCP) to assign the HAFM server IP address,
subnet mask, and default gateway IP address. You can either auto-detect or manually
select the DNS server IP address.
• Manually enter the HAFM server IP address, subnet mask, default gateway IP address, and
DNS server I
P address.
Configuring Public LAN Addresses Using DHCP
To configure TCP/IP network information for the private LAN connection (LAN 1):
Note
Befor e starting this procedure, ensure that the LAN 1 interface is physically connected to the LAN.
An LCD display of 0.0.0.0 indicates a physical LAN connection is not present.
1.
At the LCD panel, press ENTER. The Welcome!! or operational information message
changes to the following (Figure 3-4):
Figure 3.4. LCD Panel (Password Entry)
2. Using t
he
button to increment a digit, the button to decrement a digit, the button
to move
the cursor left, and the
button to move the cursor right, input the default
password (9999), then press ENTER.TheLAN 1 Setting?? message displays
at the LCD panel.
hp StorageWorks HA-F abric Manager A ppl iance Installation
Guide
37