FW V06.XX/HAFM SW V08.02.00 HP StorageWorks HA-Fabric Manager Appliance Installation Guide (AA-RU5FB-TE, July 2004)

Chapter 3. Configuration
You can config
ure the private LAN connection (LAN 2) using one of the following methods:
• Use Dynamic Host Control Protocol (DHCP) to assign the HAFM server IP address,
subnet mask, and default gateway IP address. You can either auto-detect or manually
select the DNS server IP address.
• Manually enter the HAFM server IP address, subnet mask, default gateway IP address, and
DNSserverIPaddress.
Manually Configuring Private LAN Addresses Using DHCP
To configure TCP/IP network information for the private LAN connection (LAN 2):
1.
At the LCD panel, press ENTER. The Welcome!! or operational information message
changes to the following (Figure 3-15):
Figure 3.15. LCD Panel (Password Entry)
2. Using the button to increment a digit, the button to decrement a digit, the button
to move the cursor left, and the
button to move the cursor right, input the default
password (9999), then press ENTER.TheLAN 1 Setting?? message displays
at the LCD panel.
3. Press the
button until the LAN 2 Setting?? message displays at the LCD panel.
4.
Press ENTER and the following message displays (Figure 3-16) to allow the selection of
DHCP.
Figure 3.16. LCD Panel (DHCP selection)
5.
Use the arrow keys as described in step 2 and select YES to use DHCP, then press
ENTER. The following message displays (Figure 3-17):
Figure 3.17. LCD Panel (Auto Get DNS)
hp StorageWorks HA-F abric Manager A ppl iance Installation
Guide
41