FW V06.XX/HAFM SW V08.02.00 HP StorageWorks HA-Fabric Manager Appliance Installation Guide (AA-RU5FB-TE, July 2004)

Chapter 3. Configuration

Configuring Proactive Services Call Home via LAN Feature

The HAFM appliance call-home via LAN feature provides automatic event notification to

a support center for reporting Director or Edge Switch problems. In order to report events,

this feature requires the HAFM appliance to have a valid LAN connection to a SANWorks

Management Appliance or other server running the HP Proactive Services software.

Note

To order Proactive Services software, contact your HP customer service representative.

Configuring Call-Home via LAN on the HAFM A ppliance

Use these steps to configure call-home on the HAFM appliance.

1. Verify that the HAFM appliance is connected to a LAN with access to the server running

the HP Proactive Services software.

2. Locate the hp-lan.properties file in the following location:

<install_home>\CallHome\Config

Following is an example of file contents:

CSGIpAddress=localhost

3. Using any ASCII text editor, make the following changes to the hp-lan.properties file:

a. CSGIpAddress — Delete localhost and enter the IP address of the HP Services

Gateway in appropriate format (xxx.xxx.xxx.xxx).

4. If you have changed the contents of the hp.lan.properties file, reboot the HAFM appliance.

Enabling Call-Home via L AN

The HAFM appliance is now configured to automatically call-home through the LAN

connection to a service support facility to report Director, Edge Switch, or HAFM appliance

problems.

You must now enable the call-home feature on the HAFM appliance itself as well as each

Director and Edge Switch through the HAFM application on the HAFM appliance.

To enable the call-home feature on the HAFM appliance:

1. LogintoHAFM(seeAccessing the Appliance Desktop. The HAFM main window

displays, as shown in Figure 3-43.

Select Monitor > Event Notification > Call Home.... The Call Home Event Notification

Setup dialog box displays, as shown in Figure 3-44.

Place a check mark in the Enable Call Home Event Notification option. This enables

the call-home function for the HAFM appliance, as well as for all Directors and Edge

Switches that have also been enabled for call-home notification.

hp StorageWorks HA-F abric Manager A ppl iance Installation

Guide