FW 05.01.00 and SW 07.01.00 HP StorageWorks SNMP Reference for Directors and Edge Switches Reference Guide (AA-RQ7BD-TE, June 2003)

SNMP Support
116 SNMP Reference for Directors and Edge Switches
fcConnUnitPortStatTable - Port Statistics
There is one statistics table for each individual port. For all objects in the statistics
table, if the object is not supported by the conn unit, then the high order bit is set
to 1 with all other bits set to zero. The high order bit is reserved to indicate
whether the object is supported or not. All objects start at a value of zero at
hardware initialization and continue incrementing till end of 63 bits and then wrap
to zero.
FA MIB
Object
Name
Type
HP Product Mapping from
PSCC to SWITCH.
Acces
s
Description
*fcConnUnitP
ortStatIndex
Unsigned
32
A port number, starting from 1
to maximum number of ports.
R A unique value among all
entries in this table,
between 0 and
fcConnUnitNumPort[fcConn
UnitPortUnitId]
fcConnUnitPor
tStatCountErro
r
Counter6
4
This MIB object counts
address ID errors,
CRC errors, delimiter
errors,
frames too short,
invalid transmission words,
link failures,
primitive sequence errors,
signal losses,
synchronization losses.
(Only supports low 32-bits of
counter, high 32-bits are set to
zero)
R A count of the errors that
have occurred on this port.
FcConnUnitPo
rtStatCountTx
Objects
Counter6
4
stTxFrames (64-bit counter) R The number of
frames/packets/Ios/etc
that have been transmitted
by this port. Note: A Fibre
Channel frame starts with
SOF and ends with EOF. FC
loop devices should not
count frames passed
through. This value
represents the sum total for
all other Tx objects.