SAPconnect

12 SAPconnect
SAPconnect
Configuring the Dazel SAPconnect server
Task 5: Creating a SAPconnect node
Once you have defined the communication method and format groups, you then create a
SAPconnect node. The SAPconnect node is the means by which R/3 and the Dazel
SAPconnect server communicate.
NOTE: If you intend to use Dazel SAPconnect servers for faxing and
e-mail, you have to create a separate SAPconnect node for
each: a node for faxing and a node for e-mail messages.
To create a SAPconnect node, perform the following steps:
1. In the R/3 command field, enter /nscon.
The SAPconnect: Administration (system status) screen appears.
2. Click Create.
The Create nodes screen appears.
3. Enter a name in the Node field and a short description of the node in the
Description field.
4. Click Continue.
The Create nodes screen prompts you to supply the node type that you want to
create.
5. Select RFC Node.
6. Click Continue.
The Create nodes screen prompts you to assign an RFC destination to the node.
7. In the RFC destination field, enter the RFC destination created in “Task 3: Creating
an RFC destination” on page 10 (for example, DZL_RFC_DESTINATION).
8. Click Continue.
The Node field appears in the Create nodes screen.
9. Do one of the following:
- If you are configuring the node for faxing, select Fax.
- If you are configuring the node for e-mail, select Internet.
10. Click Continue.
The Address area field appears within the Create nodes screen.