Manualshelf

SAPconnect

ManualsBrandsHP ManualsSoftwareHP Output Management Services Software
12345678910
2 SAPconnect
SAPconnect
Configuring the Dazel SAPconnect server
HP Output Server, Version 3.4.1
For information about installing HP Output Server 3.3, see Installing and
Configuring for HP Output Server 3.3. For information about installing Service
Pack 03.5 or greater for HP Output Server 3.3, see the release notes that accompany
the service pack archive file. For information about installing HP Output Server
3.4.1, see the Installation and Configuration Guide for HP Output Server 3.4.1.
• HP Output Manager for SAP 6.1 with Service Pack 03.5 or greater. For information
about installing HP Output Manager for SAP 6.1, see Using Dazel for R/3 for HP
Output Manager for SAP 6.1. For information about installing Service Pack 03.5 or
greater for HP Output Manager for SAP 6.1, see the release notes that accompany
the service pack archive file.
Configuring the Dazel SAPconnect server
Configuring a Dazel SAPconnect server is a two-part process that involves the
following:
1. configuring SAP R/3 Enterprise to work with the Dazel SAPconnect server
The following section describes the tasks that you must perform to configure SAP
R/3 Enterprise to work with the Dazel SAPconnect server.
2. configuring SAPoffice
You configure SAPoffice by testing the SAPconnect node connection to ensure that
all steps were successfully executed and the connection is operable. For more
information about configuring SAPoffice to work with the Dazel SAPconnect
server, see “Configuring SAPoffice to work with Dazel SAPconnect server”
on page 14.
Configuring SAP R/3 Enterprise
The first part of the configuration process—configuring SAP R/3 Enterprise to work
with the Dazel SAPconnect server—involves the following tasks:
1. creating the saprfc.ini file
The saprfc.ini file specifies the connection type and all RFC-specific
parameters required to connect to R/3.
2. creating the Dazel SAPconnect server
The Dazel SAPconnect server integrates the SAP BC-CON interface with HP
Output Server. You use the config_server command to create the Dazel
SAPconnect server.