HP P6000 Command View Suite 10.3 Release Notes (T5494-96584)

Unable to write to log file
After a Nested group user installed HP P6000 Command View Software Suite, HP Performance
Advisor reports errors indicating an inability to write to the log file. However, the events do appear
in the log file. These errors can be ignored.
Installation unsuccessful error
During an HP P6000 Command View Software Suite installation using HP P6000 SmartStart, if
the Command View installer displays a message indicating that the installation was unsuccessful
but HP P6000 SmartStart reports that the installation succeeded, reinstall HP P6000 Command
View.
Changing MEZ iSCSI controller management IP address
Changing the MEZ iSCSI controller management IP address requires a reboot of both the iSCSI
controllers to ensure proper peer communications.
NOTE: As a best practice, HP recommends that you should not change the management IP
address after it is configured initially.
Virtual disk operation has failed error
A change in the iSCSI controller FC frame size can result in the following error message during a
virtual disk presentation in Mez50, Mez75, or MPX200 router:
The virtual disk operation has failed. Please make sure that FC target
connections are online.
If this occurs, use the Assign path option to select a different path for LUN presentation or return
the FC frame size to the default value of 2048.
Trace history disabled in HP P6000 Command View trace logs
In HP Command View EVA 9.2 or later on server-based management, the history of trace information
that accompanies a critical (level 1) error log in the cvevatrace*.log files is disabled by default.
To generate sufficient trace information when a critical error log is observed in the trace files,
change the configuration parameter backtrace=0 to backtrace=1 at the beginning of the file
ccbtrace.cfg. This file is located in the default HP P6000 Command View installation directory,
C:\Program Files\Hewlett-Packard\Sanworks\Element Manager for
StorageWorks HSV\. You must restart the management server.
It is not necessary to restart the entire management host for this change to take effect. Restarting
the HP P6000 Command View service is sufficient.
CAUTION: Enabling trace history can adversely affect HP P6000 Command View performance.
HP Insight Remote Support Advanced software supported with HP P6000 Command View
array-based management
In addition to server-based management, HP Insight Remote Support Advanced software is supported
with array-based management. To enable array-based management support, you must set identical
credentials for both the HP P6000 Command View host (where you used discoverer.bat to
set up the connection to array-based management) and the array management module.
Verifying HP P6000 Command View code
HP products deliver on the "trustworthy and reliable" brand promise. Creating and delivering an
electronic cryptographic "signature" for HP code (such as software, firmware, drivers, applications,
patches, and solutions) provides an industry-standard method to verify the integrity and authenticity
of the code you receive from HP before deployment. Digitally signed code helps you manage your
HP P6000 Command View 7