HP StorageWorks Management Pack for System Center Operations Manager 2007 Installation and User Guide

Configuration of Management Server to process SNMP traps
Enable the SNMP Trap catcher in the HP Storage Management Pack. For information on enabling
the SNMP Trap Catcher, see Configuring the Management Pack for Processing SNMP Events\Alerts.
Please traverse to the Windows service control manager and check if the services, "SNMP Service"
and "SNMP Trap Service", are installed and started.
Create an Event or Alert view in the OpsMgr console with the target as SNMP Trap Catcher discovery.
Send some test traps from the device managed to the OpsMgr station.
Events\Alerts will be displayed in the console under the View created. If Events\Alerts are not displayed
under the view, check for any errors in the SNMP trap destination setting. Review the trap destination
setting for the Device (XP, P2000/MSA, B-series Switches, P4000, HP 3PAR Storage system, and so
on.)
Getting SNMP traps from VA
To get SNMP traps from VA, make the following changes:
In Linux
To get SNMP traps from VA, complete the following steps:
1. Open the following file: /opt/sanmgr/commandview/server/config/
PanConfigParams.txt
2. Enter the following command: SNMPTRAP_DEST=<IPs of machines to which traps
must be sent, separated by comma>
In Windows
To get SNMP traps from VA, complete the following steps:
1. Open the following file: C:\Program Files\HewlettPackard\Sanmgr\CommandView\
Server\ Config\PanConfigParams.txt
2. Enter the following command: SNMPTRAP_DEST=<IPs of machines to which traps
must be sent, separated by comma>
In HP-UX
To get SNMP traps from VA, complete the following steps:
1. Open the following file: /opt/sanmgr/commandview/server/config/
PanConfigParams.txt
2. Enter the following command: SNMPTRAP_DEST=<IPs of machines to which traps
must be sent, separated by comma>
Configuration for monitoring device46