HP StorageWorks Management Pack for System Center Operations Manager 2007 Installation and User Guide

6. Select the Enabled checkbox and set the Override Value to True.
Figure 50 Override Properties
.
NOTE:
If you enable one rule the other rule is automatically enabled.
By default, the Override value is set to 1800 seconds, where the rule takes 1800 seconds
to apply. Also, the Diagram View is refreshed every 1800 seconds. You can specify a
minimum of 300 seconds or a maximum of 1800 seconds as the override value.
For example, if you change the override value to 1120 seconds then the rule will take 1120
seconds to apply and the Diagram View will refresh every 1120 seconds.
If you change the Override Value, then navigate to the last option
select on destination Management Pack on the page, and then click New.
Type a name for the management pack and click Save.
7. Click OK.
8. Click the Monitoring tab to display the Monitoring console.
HP Storage Management Pack for System Center User Guide 83