HP StorageWorks P9000 Application Performance Extender Software User Guide (5697-0984, September 2012)

3. Run ./P9000APEX_ControllerIA64.bin.
The Welcome screen is displayed followed by the End User License Agreement.
4. Read and accept the terms of the agreement.
The Pre–installation summary is displayed. Follow the instructions to proceed.
Verifying controller installation on HP-UX and Linux hosts
HP-UX
To verify that the controller was installed successfully, run the following command:
/sbin/init.d/apex_controller status
To start the controller service, execute the /sbin/init.d/apex_controller start command.
To stop the controller service, execute the /sbin/init.d/apex_controller stop command.
Linux
To verify that the controller was installed successfully, run the following command:
service apex_controller status
To start the controller service, execute the service apex_controller start command.
To stop the controller service, execute the service apex_controller stop command.
Installing the controller on a Windows host
To install the controller on a Windows host:
1. Double-click P9000APEX_Controller.exe to start the installation.
The Installation Wizard is displayed.
2. Click Next.
The License Agreement window is displayed.
3. Read and accept the terms of the license agreement, and click Next.
The Pre–installation Summary window is displayed.
4. Click Install to proceed.
When the installation is complete, the Installation Summary window is displayed.
5. Click Done.
Verifying controller installation on a Windows host
To verify that the controller was installed successfully, ensure that the HP StorageWorks APEX Controller
Software service is running.
To confirm if the service is running:
1. Select Start > Run, type services.msc, and press Enter.
The Services window opens.
2. If the controller is installed, the status of the HP StorageWorks P9000 APEX Controller Software
service is in the Started mode.
3. Close the Services window.
Installing and removing P9000 Application Performance Extender20