HP StorageWorks P9000 Application Performance Extender Software User Guide (5697-0984, September 2012)

DescriptionItem
Displays the email ID to which notifications are dispatched.Destination Address
Displays the alarm status as Active or Dormant.Active
Enables you to filter alarms.Disable Filter
Enables you to create an alarm.Create Alarm
Enables you to update an alarm.Update Alarm
Enables you to remove an alarm.Delete Alarm
Creating alarms
To create alarms:
1. Select Alarms from the Navigation pane.
The Alarms screen is displayed (see Figure 36.
2. Click the Alarm Configuration tab.
3. Click Create Alarm.
The Alarm window is displayed, as shown in Figure 37.
Figure 37 Create Alarm window
.
4. Select the source of the alarm from the Alarm Source list.
5. Select the source IP address from the Source Address list.
The Source Address field is enabled only if the Source IP Address is applicable to the selected
Source.
6. Select an event from the Event list.
7. Select the event state from the Event State list.
8. Enter a Deviation amount in percentage.
HP StorageWorks P9000 Application Performance Extender Software User Guide 85