Hitachi Dynamic Link Manager Software Users Guide for AIX

Specifies the severity level of audit log data to be collected. The table
below lists and describes the values used for this setting. The default
is 6.
Table 6-7 Values Indicating Audit Log Data Collection Levels
Value (severity) Explanation
0 No audit log data is collected.
1
2 Critical-level audit log data is collected.
3 Critical-level and Error-level audit log data is collected.
4 Critical-level, Error-level, and Warning-level audit log data is
collected.
5
6 Critical-level, Error-level, Warning-level, and Informational-
level audit log data is collected.
7
-category [[ss] [a] [ca]|all]
Specifies the categories of audit log data to be collected. The table
below lists and describes the values used for this setting. The default
is all. Note that if you enter -category without specifying any
category (ss, a, ca, or all), it is assumed that all is specified.
Table 6-8 Values Indicating Audit Log Data Categories
Value Explanation
ss
Audit log events of the StartStop category are collected.
a
Audit log events of the Authentication category are
collected.
ca
Audit log events of the ConfigurationAccess category are
collected.
all
Audit log events of the StartStop, Authentication, and
ConfigurationAccess categories are collected.
-audfac facility-value
Specifies the audit log facility.
The table below lists the values used for this setting. The default is user.
Table 6-9 Values of the Audit Log Facility
Value Corresponding facility value in the /etc/syslog.conf file
user or 1
user
local0 or 16
local0
6-30
Command Reference
Hitachi Dynamic Link Manager (for AIX) User Guide