Hitachi Dynamic Link Manager Software Users Guide for VMWare

KAPL01061-I 2 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
PROMPT>
-pathid AutoPATH_ID
Use this parameter to place a single path online.
Specify the current AutoPATH_ID of the target path, which is displayed by
using the view operation. For details about the view operation, see
view
(Displays Information) on page 6-25. Leading zeros can be omitted
(000001 and 1 indicate the same AutoPATH_ID); however, when the
target AutoPATH_ID is 000000, enter 000000 or 0 for the parameter
value.
AutoPATH_IDs are re-assigned every time the host is restarted. Always
make sure that you use the view operation to find the current
AutoPATH_ID of the target path, before executing the online operation.
-hbaportwwn HBA-port-WWN
Use this parameter to place online all the paths connected to an HBA port
associated with a specific HBA port WWN. Only one set of values can be
specified for the -hbaportwwn parameter.
For HBA-port-WWN, specify the value of HBAPortWWN. The parameter is
not case sensitive.
To display HBAPortWWN and PathName, execute the view operation as
follows:
dlnkmgr view -path -hbaportwwn
For details on how to execute the view operation and display the HBA
port WWN and path name, see
To display path information on page 6-33
in Parameters (To display program information) on page 6-27.
Example
The following shows an example of placing online the paths for which
the HBA port WWN is 10000000C93213BA while confirming command
operation.
PROMPT>dlnkmgr online -path -hbaportwwn 10000000C93213BA
KAPL01050-I The currently selected paths will be changed to
the Online status. Is this OK? [y/n]: y
KAPL01061-I 1 path(s) were successfully placed Online; 0
path(s) were not. Operation name = online
PROMPT>
-hapath
Use this parameter to change to the Online status when the paths to the
primary volume (P-VOL) in an HAM environment are in the Online(S) or
Online(D) status. To change the status of a specific LU, use the -lu and
-pathid parameters to specify the path to the LU. To change the status
Command Reference
6-13
Hitachi Dynamic Link Manager (for VMware®) User Guide