Hitachi Dynamic Link Manager Software Users Guide for VMWare

Checking the Current Settings
Check the current settings by executing the following command to set the
HDLM functionality by using the dlnkmgr command's view operation.
PROMPT>dlnkmgr -s host-name -u user-name -p password view -sys -sfunc
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
To check the current audit log settings, execute the following command:
PROMPT>dlnkmgr -l view -sys -audlog
Audit Log : off
Audit Log Category : -
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
PROMPT>
Setting Up the HDLM Functions
The table below summarizes the functions that can be set in HDLM. For
details about each function, see
Setting Up Load Balancing on page 3-17
and subsequent sections.
Each function has a default value and a recommended value. If no function is
set by the HDLM command's set operation, the default value is applied for
each function. The recommended values are used as the guideline values
when functions are configured.
Table 3-4 The Recommended and Default Values of Each Function
Function Default value Recommended value
Load-balancing The Extended Least I/Os
algorithm is used.
The recommended algorithm
depends on the operating
environment.
Intermittent Error
Monitor
off on
Dynamic I/O path
control
#
off
10-minute check interval
off
The recommended checking
interval depends on the
operating environment.
Collection of audit log
data
off The recommended value
depends on the operating
environment.
3-16
Creating an HDLM Environment
Hitachi Dynamic Link Manager (for VMware®) User Guide