Hitachi Dynamic Link Manager Software Users Guide for VMWare

Value (severity) Explanation

6 Error-level, Warning-level, and Information-level

audit log data is collected.

The table below lists and describes the values for the audit log category

setting.. The default is all.

Table 3-6 Values Indicating Audit Log Data Categories

Value Explanation

Audit log events of the StartStop category are collected.

Audit log events of the Authentication category are collected.

Audit log events of the ConfigurationAccess category are collected.

all

Audit log events of the StartStop, Authentication, and

ConfigurationAccess categories are all collected.

This example shows how to enable the collection of audit log data:

dlnkmgr -l set -audlog on -audlv 6 -category all

Specify on if you want to collect audit log data, and off if you do not want to

collect audit log data. If you specify on, you can use the -audlv parameter to

specify the collection level for audit log data and the -category parameter to

specify the audit log categories.

Checking the Updated Settings

This chapter describes steps involved in how to check the new settings by

using the dlnkmgr command's set operation after the new settings are

applied.

When you some these settings, you can display information about all of HDLM

function settings. The following is an example of executing the command:

PROMPT>dlnkmgr -s host-name -u user-name -p password view -sys -sfunc

HDLM Version : x.x.x-xx

Service Pack Version :

Load Balance : on(extended lio)

Intermittent Error Monitor : on(2/20)

Dynamic I/O Path Control : off(10)

KAPL01001-I The HDLM command completed normally. Operation name =

view, completion time = yyyy/mm/dd hh:mm:ss

PROMPT>

After you have set up the collection of audit log data, use the following

command to make sure that the setting has been specified correctly:

PROMPT>dlnkmgr -l view -sys -audlog

Creating an HDLM Environment

3-19

Hitachi Dynamic Link Manager (for VMware®) User Guide