8.14.01 HP Utility Meter User's Guide (June 2009)

# /usr/sbin/swremove T5462A
6. Install version 8.14.01 of the Utility Meter software, using the installation procedure in Installing the
Utility Meter Software.
7. Configure the Utility Meter's networking, using the configuration procedure in Configuring the Utility
Meter Parameters. The networking details specified in the meter configuration file (meter.xml) that
was saved in Step 1 can help as a source of information.
8. If there are Utility Ready Storage (URS) XP devices that need to be metered, install a supported version
of the HP StorageWorks XP Command View Advanced Edition Command Line Interface (CLI) software.
For more information about this type of installation, see URS XP Only – Installing the XP CVAE CLI
Software.
9. If there are Utility Ready Storage (URS) EVA devices that need to be metered, install a supported version
of the HP StorageWorks Storage System Scripting Utility (SSSU) software. For more information about
this type of installation, see URS EVA Only – Installing the CV EVA SSSU Software.
10. Add all servers, disk arrays and SAN switches that were registered in the previous Utility Meter version
into the new 8.14.01 version. The meter.xml file that was saved in Step 1 can help as a source of
information.
11. Follow the Utility Meter verification procedure in Chapter 4: “Verifying Utility Meter Operation”.
2.15 Upgrading the Utility Meter Software to Version 8.14.01 39