HP VPN Firewall Appliances Network Management Configuration Guide

80
Figure 52 Configuring global MSTP parameters on Device A
Configuring Device B
1. Configure the MST region name as example, map VLAN 10, VLAN 30, and VLAN 40 to MSTI 1,
MSTI 3, and MSTI 4, respectively, and configure the revision level of the MST region as 0. (The
procedure here is the same as that of configuring an MST region on Device A.)
2. Enable MSTP globally and configure the current device as the root bridge of MSTI 3:
a. From the navigation tree, select Network > MSTP > Global.
b. Perform the following configurations on the page similar to that shown in Figure 52:
− Sel
ect Enable from the
Enable STP Globally list.
− Select MSTP from the Mode list.
− Select the Instance box.
− Set the Instance ID field to 3.
− Set the Root Type field to Primary.
c. Click Apply.