HP VPN Firewall Appliances Network Management Configuration Guide

107
[DeviceD] stp enable
Verifying the configuration
In this example, suppose Device B has the lowest root bridge ID. As a result, Device B is elected as the
root bridge of MSTI 0.
You can use the display stp brief command to display brief spanning tree information on each device
after the network is stable.
# Display brief spanning tree information on Device A.
[DeviceA] display stp brief
MSTID Port Role STP State Protection
0 GigabitEthernet0/1 ALTE DISCARDING NONE
0 GigabitEthernet0/2 DESI FORWARDING NONE
0 GigabitEthernet0/3 ROOT FORWARDING NONE
1 GigabitEthernet0/1 DESI FORWARDING NONE
1 GigabitEthernet0/3 DESI FORWARDING NONE
3 GigabitEthernet0/2 DESI FORWARDING NONE
3 GigabitEthernet0/3 ROOT FORWARDING NONE
# Display brief spanning tree information on Device B.
[DeviceB] display stp brief
MSTID Port Role STP State Protection
0 GigabitEthernet0/1 DESI FORWARDING NONE
0 GigabitEthernet0/2 DESI FORWARDING NONE
0 GigabitEthernet0/3 DESI FORWARDING NONE
1 GigabitEthernet0/2 DESI FORWARDING NONE
1 GigabitEthernet0/3 ROOT FORWARDING NONE
3 GigabitEthernet0/1 DESI FORWARDING NONE
3 GigabitEthernet0/3 DESI FORWARDING NONE
# Display brief spanning tree information on Device C.
[DeviceC] display stp brief
MSTID Port Role STP State Protection
0 GigabitEthernet0/1 DESI FORWARDING NONE
0 GigabitEthernet0/2 ROOT FORWARDING NONE
0 GigabitEthernet0/3 DESI FORWARDING NONE
1 GigabitEthernet0/1 ROOT FORWARDING NONE
1 GigabitEthernet0/2 ALTE DISCARDING NONE
4 GigabitEthernet0/3 DESI FORWARDING NONE
# Display brief spanning tree information on Device D.
[DeviceD] display stp brief
MSTID Port Role STP State Protection
0 GigabitEthernet0/1 ROOT FORWARDING NONE
0 GigabitEthernet0/2 ALTE DISCARDING NONE
0 GigabitEthernet0/3 ALTE DISCARDING NONE
3 GigabitEthernet0/1 ROOT FORWARDING NONE
3 GigabitEthernet0/2 ALTE DISCARDING NONE
4 GigabitEthernet0/3 ROOT FORWARDING NONE
Based on the output, you can draw the MSTI mapped to each VLAN, as shown in Figure 59.