HP VPN Firewall Appliances Network Management Configuration Guide

112
Enabling PPP encapsulation on an interface
The following matrix shows the feature and hardware compatibility:
Hardware Com
p
atibilit
y
F1000-A-EI/F1000-S-EI Yes
F1000-E No
F5000 No
F5000-S/F5000-C No
VPN firewall modules No
20-Gbps VPN firewall modules No
To enable PPP encapsulation on an interface:
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface interface-type
interface-number
N/A
3. Enable PPP
encapsulation on the
interface.
link-protocol ppp
Optional.
Only dialer interfaces support this command.
By default, dialer interfaces use PPP as the link layer
protocol.
Configuring PPP authentication
You can configure several authentication modes simultaneously. In LCP negotiation, the authenticator
negotiates with the peer in the sequence of configured authentication modes until the LCP negotiation
succeeds. If the response packet from the peer carries a recommended authentication mode, the
authenticator directly uses the authentication mode if it finds the mode configured.
Configuring PAP authentication
1. Configuring the authenticator
Ste
p
Command Remarks
1. Enter system view.
system-view N/A
2. Enter interface view.
interface
interface-type interface-number
N/A
3. Configure the local
device to authenticate
the peer by using PAP.
ppp authentication-mode pap
[ [
call-in
]
domain
isp-name ]
By default, PPP
authentication is disabled.